●Introduction
●The Atmel® ATtiny4/5/9/10 is a low-power CMOS 8-bit microcontroller based on the AVR® enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATtiny4/5/9/10 achieves throughputs close to 1 MIPS per MHz. This empowers system designer to optimize the device for power consumption versus processing speed.
●Feature
●• High Performance, Low Power AVR® 8-Bit Microcontroller
●• Advanced RISC Architecture
● – 54 Powerful Instructions
● – Most Single Clock Cycle Execution
● – 16 x 8 General Purpose Working Registers
● – Fully Static Operation
● – Up to 12 MIPS Throughput at 12 MHz
●• Non-volatile Program and Data Memories
● – 512/1024 Bytes of In-System Programmable Flash Program Memory
● – 32 Bytes Internal SRAM
● – Flash Write/Erase Cycles: 10,000
● – Data Retention: 20 Years at 85°C / 100 Years at 25°C
●• Peripheral Features
● – QTouch® Library Support for Capacitive Touch Sensing (1 Channel)
● – One 16-bit Timer/Counter with Prescaler and Two PWM Channels
● – Programmable Watchdog Timer with Separate On-chip Oscillator
● – 4-channel, 8-bit Analog to Digital Converter (ATtiny5/10, only)
● – On-chip Analog Comparator
●• Special Microcontroller Features
● – In-System Programmable (at 5V, only)
● – External and Internal Interrupt Sources
● – Low Power Idle, ADC Noise Reduction, and Power-down Modes
● – Enhanced Power-on Reset Circuit
● – Programmable Supply Voltage Level Monitor with Interrupt and Reset
● – Internal Calibrated Oscillator
●• I/O and Packages
● – Four Programmable I/O Lines
● – 6-pin SOT and 8-pad UDFN
●• Operating Voltage:
● – 1.8 - 5.5V
●• Programming Voltage:
● - 5V
●• Speed Grade:
● – 0 - 4 MHz @ 1.8 - 5.5V
● – 0 - 8 MHz @ 2.7 - 5.5V
● – 0 - 12 MHz @ 4.5 - 5.5V
●• Industrial and Extended Temperature Ranges
●• Low Power Consumption
● – Active Mode:
● • 200μA at 1MHz and 1.8V
● Idle Mode:
● • 25μA at 1MHz and 1.8V
● – Power-down Mode:
● • <0.1μA at 1.8V
