AD8314ACP-EVALZ Datasheet PDF - ADI

●The AD8314ACP-EVAL is an evaluation board for AD8314ACP device with 8-lead LFCSP package. This board is a fully populated, 4-layer, FR4 based evaluation board. For normal operation, it requires a 2.7V to 5V/10mA power supply. The power supply should be connected to the vector pins leads labelled VPOS and GND. The RF input signal is applied to the edge mounted SMA type RF connector (INPUT). The set point input signal is applied to the edge mounted SMA type connector (VSET). The detector output signals are accessible via the edge mounted SMA connectors (V_UP, V_DN). The circuit board can accommodate configuration in measurement mode and controller mode depending on the status of jumper (LK1).

● Complete RF detector/controller function

● Typical range of-58dBV to -13dBV

● Frequency response from 100MHz to 2.7GHz

● Temperature stable linear-in-dB response

● Rapid response of 70ns to a 10dB step

● Low power consumption of 12mW at 2.7V

● Power down to 20µA