●Overview
●The ATmega162 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega162 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.
●Features
●• High-performance, Low-power AVR® 8-bit Microcontroller
●• Advanced RISC Architecture
● – 131 Powerful Instructions – Most Single-clock Cycle Execution
● – 32 x 8 General Purpose Working Registers
● – Fully Static Operation
● – Up to 16 MIPS Throughput at 16 MHz
● – On-chip 2-cycle Multiplier
●• High Endurance Non-volatile Memory segments
● – 16K Bytes of In-System Self-programmable Flash program memory
● – 512 Bytes EEPROM
● – 1K Bytes Internal SRAM
● – Write/Erase cycles: 10,000 Flash/100,000 EEPROM
● – Data retention: 20 years at 85°C/100 years at 25°C(1)
● – Optional Boot Code Section with Independent Lock Bits In-System Programming by On-chip Boot Program True Read-While-Write Operation
● – Up to 64K Bytes Optional External Memory Space
● – Programming Lock for Software Security
●• JTAG (IEEE std. 1149.1 Compliant) Interface
● – Boundary-scan Capabilities According to the JTAG Standard
● – Extensive On-chip Debug Support
● – Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG Interface
●• Peripheral Features
● – Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes
● – Two 16-bit Timer/Counters with Separate Prescalers, Compare Modes, and Capture Modes
● – Real Time Counter with Separate Oscillator
● – Six PWM Channels
● – Dual Programmable Serial USARTs
● – Master/Slave SPI Serial Interface
● – Programmable Watchdog Timer with Separate On-chip Oscillator
● – On-chip Analog Comparator
●• Special Microcontroller Features
● – Power-on Reset and Programmable Brown-out Detection
● – Internal Calibrated RC Oscillator
● – External and Internal Interrupt Sources
● – Five Sleep Modes: Idle, Power-save, Power-down, Standby, and Extended Standby
●• I/O and Packages
● – 35 Programmable I/O Lines
● – 40-pin PDIP, 44-lead TQFP, and 44-pad MLF
●• Operating Voltages
● – 1.8 - 5.5V for ATmega162V
● – 2.7 - 5.5V for ATmega162
●• Speed Grades
● – 0 - 8 MHz for ATmega162V (see Figure 113 on page 266)
● – 0 - 16 MHz for ATmega162 (see Figure 114 on page 266)
