DRV8412DDWEVM Datasheet PDF - TI

●The DRV8412DDWEVM is an evaluation module to evaluate DRV8412 dual full bridge PWM motor driver. It has a maximum recommended supply voltage of 52V and is capable of delivering 2x3A RMS output current and 2x6A peak current per device. The DRV8412 has an advanced protection system consisting of short-circuit protection, over current protection, under voltage protection and two stage thermal protection. The evaluation module can be operated with either two full bridge outputs or four half bridge outputs. It can also be used in parallel mode to double the current capability. The unit can be operated with external PWM inputs using a MCU controller module or signal generator, etc. The outputs and power supplies can be connected using stripped wires by connecting them to the on board terminal blocks. The evaluation module module also has hardware switches to control the modes and to allow a manual reset.

● Evaluates DRV8412 dual full bridge PWM motor driver

● 2 x 6A Peak/2 x 3A RMS current output

● 1 x 12A Peak/1 x 6A RMS current output

● Wide operating voltage from 0 to 52V (12V gate drive)

● PWM control interface

● Advanced protection systems short-circuit/over current/under voltage & 2 stage thermal protection

● On board header/test points for external control of the DRV8412

● Self contained protection system

● Double side, plated through PCB layout