DS1804U-010+T&R Datasheet PDF - Maxim Integrated

●The DS1804U-010+T&R from Maxim Integrated Products is a non-volatile trimmer potentiometer in 8 pin µSOP package. The device provides an ideal method for low cost trimming applications using a CPU or manual control input with minimal external circuitry. Wiper position of the DS1804 can be stored in EEPROM memory and its position is manipulated by a three terminal port that provides an increment/decrement counter controlled interface. This port consists of the control inputs active-low CS, active-low INC and U/active-low D. On power-up, the DS1804 will load the value of EEPROM memory into the wiper position register or (1 of 100decoder). On power-down, the wiper position register data will be lost.

● Supply voltage range from 2.7V to 5.5V

● Operating temperature range from -40°C to 85°C

● Single 100 position taper potentiometer

● Up/down, increment controlled interface

● Non-volatile on demand wiper storage

● Specified to accept 50,000 writes to EEPROM over 0°C to 70°C

● End to end resistance is 10Kohm at ±20% tolerance and temperature coefficient is 750ppm/°C

● Power-up time is 50ms, absolute linearity is ±0.6LSB, relative linearity is ±0.25LSB

● Easily used as an OTP (one time programmability) device

● Wiper resistance is 400 ohm and wiper current is 1mA

● Signal Processing