●The FXL2SD106 is a configurable dual-voltage-supply translator designed for both uni-directional and bidirectional voltage translation between two logic levels. The device allows translation between voltages as high as 3.6V to as low as 1.1V. The A port tracks the V level and the B port tracks the V level. This allows for bi-directional voltage translation over a variety of voltage levels: 1.2V, 1.5V, 1.8V, 2.5V, and 3.3V.The device remains in 3-state until both VCC reach active levels, allowing either V to be powered-up first. Internal power-down control circuits place the device in 3-state if either VThe OE input, when low, disables both A and B ports by placing them in a 3-state condition. The FXL2SD106 is designed so that OE and CLK IN are supplied by VThe device senses an input signal on A or B port automatically. The input signal is transferred to the other port. The FXL2SD106 is not designed for SD card applications. The internal bus hold circuitry conflicts with pull-up resistors. SD cards have internal pull-up resistors on the CD/DAT3 pins.
●Features
●---
● |
● Bi-Directional Interface between Two Levels: 1.1V and 3.6V
● Fully Configurable: Inputs and Outputs Track VCC Level
● Non-Preferential Power-up; Either VCC May Be Powered-up First
● Outputs Remain in 3-State until Active VCC Level is Reached
● Outputs Switch to 3-State if Either VCC is at GND
● Power-Off Protection
● Bus HOLD on Data Inputs Eliminates Need for Pullup Resistors (Do NOT Use Resistors on the A or B Ports)
● OE and CLK IN are Referenced to VCCA Voltage
● Packaged in 16-Terminal DQFN (2.5mm x 3.5mm)
● Direction Control Not Needed
● 80Mbps Throughput Translating between 1.8V and 2.5V
● ESD Protection Exceeds:
● 12kV HBM (B port I/O to GND) (per JESD22-A114 & Mil Std 883e 3015.7)
● 8kV HBM (A port I/O to GND) (per JESD22-A114 & Mil Std 883e 3015.7)
● 1kV CDM (per ESD STM 5.3)
