●The FXMA108 is a configurable dual-voltage supply translator designed for both uni-directional and bidirectional voltage translation between two logic levels. The device allows translation between voltages as high as 5.5V to as low as 1.65V. The A port tracks the V level and the B port tracks the V level. This allows for bi-directional voltage translation over a variety of voltage levels: 1.8V, 2.5V, 3.3V, and 5.0V The device remains in 3-state until both Vs reach active levels, allowing either V to be powered-up first. Internal power-down control circuits place the device in 3-state if either V is removed. The /OE input, when high, disables both the A and B Side by placing them in a 3-state condition. The /OE input is supplied by V. The FXMA108 supports bi-directional translation without the need for a direction control pin. The two Side of the device have auto-direction-sense capability. Either port may sense an input signal and transfer it as an output signal to the other port.
●Features
●---
● |
● Bi-Directional Interface between Two Levels from 1.65V to 5.5V
● Fully Configurable: Inputs and Outputs Track VCC
● Non-Preferential Power-Up; Either VCC May Be Powered-Up First
● Outputs Remain in 3-State Until Active VCC Level is Reached
● Outputs Switch to 3-State if Either VCC is at GND
● Power-Off Protection
● Bus-Hold on Data Inputs Eliminates the Need for Pull-Up Resistors
● Control Input (/OE) Referenced to VCCA Voltage
● Packaged in 20-Terminal DQFN
● Direction Control Not Necessary
● 80Mbps Throughput when Translating Between 2.5V and 5.0V
● ESD Protection Exceeds:
● 8kV Human Body Mode (B Port I/O to GND) (JESD22-A114 & Mil Std 883e 3015.7)
● 5kV Human Body Model (A Port I/O to GND) (JESD22-A114 & Mil Std 883e 3015.7)
● 2kV Charged Device Model (ESD STM 5.3) (JESD22-C101)
Part 3D Model
