●The ISO3080 and ISO3086 devices are isolated full-duplex differential line drivers and receivers while the ISO3082 and ISO3088 devices are isolated half-duplex differential line transceivers for TIA/EIA 485/422 applications.
●These devices are ideal for long transmission lines because the ground loop is broken to allow for a much larger common-mode voltage range. The symmetrical isolation barrier of the device is tested to provide 2500 Vrms of isolation for 60s per UL 1577 between the bus-line transceiver and the logic-level interface.
●Any cabled I/O can be subjected to electrical noise transients from various sources. These noise transients can cause damage to the transceiver and/or nearby sensitive circuitry if they are of sufficient magnitude and duration. These isolated devices can significantly increase protection and reduce the risk of damage to expensive control circuits.
●The ISO3080, ISO3082, ISO3086, and ISO3088 are qualified for use from –40°C to 85°C.
● Meets or Exceeds TIA/EIA RS-485 Requirements
● Signaling Rates up to 20 Mbps
● 1/8 Unit Load – Up to 256 Nodes on a Bus
● Thermal Shutdown Protection
● Low Bus Capacitance – 16 pF (Typical)
● 50 kV/µs Typical Transient Immunity
● Fail-safe Receiver for Bus Open, Short, Idle
● 3.3-V Inputs are 5-V Tolerant
● Bus-Pin ESD Protection
● 12 kV HBM Between Bus Pins and GND2
● 6 kV HBM Between Bus Pins and GND1
● Safety and Regulatory Approvals
● 4000-VPK Basic Insulation, 560 VPK VIORM
●per DIN V VDE V 0884-10 (VDE V 0884-10):
●2006-12 and DIN EN 61010-1
● 2500 VRMS Isolation per UL 1577
● 4000 VPK Isolation per CSA Component
●Acceptance Notice 5A and IEC 60950-1
Part 3D Model
