LNK302DN Datasheet PDF - Power Integrations

●The LNK302DN is a LinkSwitch-TN lowest component count, Energy-efficient Off-line Switcher IC. It is specifically designed to replace all linear and capacitor-fed (cap dropper) non-isolated power supplies in the under 360mA output current range at equal system cost while offering much higher performance and energy efficiency. This device integrate a 700V power MOSFET, oscillator, simple on/off control scheme, a high voltage switched current source, frequency jittering, cycle-by-cycle current limit and thermal shutdown circuitry onto a monolithic IC. The start-up and operating power are derived directly from the voltage on the DRAIN pin, eliminating the need for a bias supply and associated circuitry in buck or flyback converters. The fully integrated auto-restart circuit in the safely limits output power during fault conditions such as short-circuit or open loop and reducing component count.

● Lowest component count buck converter solution

● Uses a simplified controller without auto-restart

● Tight tolerances and negligible temperature variation

● Supports buck, buck-boost and flyback topologies

● Excellent line and load regulation even with typical configuration

● High bandwidth provides fast turn-on with no overshoot

● Current limit operation rejects line ripple

● Universal input voltage range (85 to 265VAC)

● Built-in current limit and hysteretic thermal protection

● Higher efficiency than passive solutions

● Higher power factor than capacitor-fed solutions

● Entirely manufacturable in SMD