LPC1114FDH28/102:5 Datasheet PDF - NXP

●Overview

● The LPC1114FDH28 is an ARM Cortex-M0 based, low-cost 32-bit MCU, designed for 8/16-bit microcontroller applications, offering performance, low power, simple instruction set and memory addressing together with reduced code size compared to existing 8/16-bit architectures. The LPC1114FDH28 operates at CPU frequencies of up to 50 MHz. The LPC1114FDH28 includes up to 32 kB of flash memory, up to 4 kB of data memory, one Fastmode Plus I²C-bus interface, one RS-485/EIA-485 UART, one SPI interface with SSP features, four general purpose counter/timers, a 10-bit ADC, and up to 22 general purpose I/O pins.

●MoreLess

●## Features

● ARM Cortex-M0 processor, running at frequencies of up to 50 MHz

● ARM Cortex-M0 built-in Nested Vectored Interrupt Controller (NVIC)

● Serial Wire Debug

● System tick timer

● 32 kB on-chip flash programming memory

● 4 kB SRAM

● In-System Programming (ISP) and In-Application Programming (IAP)

● 22 General Purpose I/O (GPIO) pins with configurable pull-up/-down resistors

● High-current output driver (20 mA) on one pin

● Programmable WatchDog Timer (WDT)

● 10-bit ADC with input multiplexing among 5 pins

● UART with fractional baud rate generation

● One SPI controller with SSP features and FIFO and multi-protocol capabilities

● I²C-bus interface supporting full I²C-bus specification and Fast-mode Plus

● Integrated PMU (Power Management Unit) to minimize power consumption

● Power profiles residing in boot ROM (LPC1100Land LPC1100XL series only)

● Unique device serial number for identification

● Single 3.3 V power supply (1.8 V to 3.6 V)

● Four general purpose counter/timers

●## Target Applications

● eMetering

● Alarm systems

● Lighting

● White goods

●## Features