●The LPC2129FBD64/01 is a 16/32-bit Microcontroller based on ARM7TDMI-S CPU with real-time emulation and embedded trace support. A 128-bit wide memory interface and an unique accelerator architecture enable 32-bit code execution at maximum clock rate. For critical code size applications, the alternative 16-bit Thumb mode reduces code by more than 30 % with minimal performance penalty. The device incorporates 256kB internal flash, 16kB internal RAM, 4-channel 10-bit A/D converter, various 32-bit timers, PWM channels and 46 general-purpose I/O pins.
● In-system programming (ISP) and In-application programming (IAP)
● EmbeddedICE-RT interface enables breakpoints and watch points
● Embedded trace macrocell enables non-intrusive high speed real-time tracing of instruction execution
● Multiple serial interfaces including two UARTs (16C550), fast I2C-bus (400 Kbit/s) and two SPIs
● 60MHz Maximum CPU clock available from programmable on-chip phase-locked loop
● Vectored interrupt controller with configurable priorities and vector addresses
● Up to forty-six 5V tolerant general purpose I/O pins
● On-chip crystal oscillator with an operating range of 1MHz to 30MHz
● Two low power modes, Idle and power-down
● Processor wake-up from power-down mode via external interrupt
● Individual enable/disable of peripheral functions for power optimization
● Fast GPIO ports enable port pin toggling up to 3.5 times faster than the original device
● Dedicated result registers for ADC reduce interrupt overhead
● The ADC pads are 5V tolerant when configured for digital I/O function
● UART0/1 include fractional baud rate generator, auto-bauding capabilities & handshake flow-control
● Buffered SSP serial controller supporting SPI, 4-wire SSI and microwire formats
● SPI programmable data length and master mode enhancement
● Diversified code read protection (CRP)
● General purpose timers can operate as external event counters
