MAX14820ETG+ Datasheet PDF - Maxim Integrated

●The MAX14820ETG+ is an IO-Link device transceiver in 24 pin TQFN package. This transceiver is suitable for IO-Link devices and 24V binary sensors/actuators. All specified IO-Link data rates are supported. In IO-Link applications, the transceiver acts as physical layer interface to a microcontroller running data link layer protocol. Additional 24V digital inputs and outputs are provided. Two internal linear regulators generate common sensor and actuator power requirements (5V and 3.3V). Onboard C/Q and DO drivers are independently configurable for push-pull, high side (PNP) or low side (NPN) operation. The device detects IO-Link C/Q wake-up condition and generates wake-up signal on active-low WU output. The SPI interface allows configuration and monitoring of the devices. The C/Q driver is specified for sinking/sourcing ±300mA. The DO driver is specified for sinking/sourcing ±135mA. The MAX14820 is used in IO-Link sensors and IO-Link actuators.

● Supply voltage range from 9V to 36V

● Operating temperature range from -40°C to 85°C

● Industry"s highest C/Q drive capability enables fast data rates for long cable runs

● IO-Link specification V1.0 and V1.1 physical layer compliant

● Supports COM1, COM2 and COM3 data rates

● IO-Link device wake-up detection

● 2.5V to 5V logic interface levels and 1mA VCC supply current

● High temperature warning and thermal shutdown, extensive fault monitoring and reporting

● Reverse polarity and short circuit protection on all 24V inputs/outputs

● Data rate of 230.4Kbps (HiSlew = 1) and 38.4Kbps (HiSlew = 0)