MC9S08DZ60AMLH Datasheet PDF - NXP

●The MC9S08DZ60AMLH is a 8-bit Embedded CAN Microcontroller based on enhanced HCS08 CPU (20MHz bus) with CISC architecture operates at a maximum frequency of 40MHz. The device incorporates 60kB internal flash, 4kB internal RAM, an analog comparator, a can, 24-channel 12-bit A/D converter and 54 general-purpose I/O pins. This device also features peripherals like multi-scalable controller area networks (MSCAN) CAN 2.0 A/B software compatible module, one inter-integrated circuit (IIC) bus module to operate at up to 100kbps, one serial peripheral interface modules (SPI), two serial communications interface (SCI) modules and real-time counter (RTC).

● HC08 Instruction set with added BGND instruction

● Support for up to 32 Interrupt/reset sources

● Two very low power stop modes

● Reduced power wait mode

● Very low power real time interrupt for use in run, wait and stop

● Loop-control Pierce oscillator (XOSC)

● Multi-purpose clock generator (MCG)

● Watchdog computer operating properly (COP) reset

● Low-voltage detection with reset or interrupt - selectable trip points

● Illegal opcode detection with reset

● Illegal address detection with reset

● Flash block protect

● Loss-of-lock protection

● MSCAN - CAN protocol version 2.0 A, B

● Two SCIs supporting LIN 2.0 protocol and SAE J2602 protocols

● 24 Interrupt pins with selectable polarity on each pin

● Hysteresis and configurable pull device on all input pins

● Configurable slew rate and drive strength on all output pins

● Single-wire background debug interface

● On-chip, in-circuit emulation (ICE) with real-time bus capture