●Overview
●The S08QG Family of microcontrollers provide a wide variety of serial interfaces and peripherals, normally found in higher-end devices, all in a small package. Featuring low-power S08 8-bit architecture, S08QG devices are a perfect fit for battery-powered devices.
●MoreLess
●## Features
●### 8-bit HCS08 Central Processing Unit (CPU)
● Up to 20 MHz HCS08 CPU (10 MHz bus frequency) for 100 ns minimum instruction time
● HCS08 instruction set with added BGND instruction
● Support for up to 32 interrupt/reset sources
●### Integrated Third-Generation Flash Memory and RAM
● Embedded flash that is in-application reprogrammable
● Extremely fast, byte-writable programming (20 µs/byte)
● Up to 100,000 write/erase cycles at typical voltage and temperature (10k minimum write/erase)
● 100 years typical data retention (15 years minimum)
●### Flexible Clock Options
● Internal clock source (ICS) module containing a frequency-locked loop (FLL) controlled by internal or external reference
● Precision trimming of internal reference allows typical 0.1 percent resolution and +0.5 percent to -1 percent deviation over operating temperature and voltage
● Internal reference can be trimmed from 31.25 kHz to 39.065 kHz, allowing for 8 MHz to 10 MHz FLL output
● Low-power oscillator module (XOSC) with software selectable crystal or ceramic resonator range, 31.25 kHz to 38.4 kHz or 1MHz to 16 MHz, and supports external clock source input up to 20 MHz
●### Input/Output
● 12 Bidirectional Input/Output (I/O) Lines
● One Input Only and One Output Only Line
● Outputs 10 mA each; 60 mA max for package
● Software selectable pull-ups on ports when used as input
● internal pull-up on reset and interrupt request (IRQ) pin
● Software selectable slew rate control and drive strength on ports when used as output
● 8-pin keyboard interrupt module with software selectable polarity on edge or edge/level modes
●### Integrated Analog Peripherals
● 8-ch., 10-bit analog-to-digital converter (ADC)
● Automatic compare function, software programmable for greater than/equal to or less than conditions
● Asynchronous clock source
● Temperature sensor
● Internal bandgap reference channel
● Hardware triggerable using the RTI counter
● Low-power and high-speed options
● Analog comparator module (ACMP)
● Option to compare to internal reference
● Option to route comparator output directly to pin
● Output can be optionally routed to TPM module as input capture trigger
●### Two Timer Modules
● Programmable 16-bit timer/PWM module (TPM)
● 8-bit modulo timer module (MTIM) with 8-bit prescaler
●### System Protection
● Watchdog computer operating properly (COP) reset with option to run from dedicated 1 kHz internal clock source or bus clock
● Low-voltage detection with reset or interrupt
● Illegal op code detection with reset
● Flash block protection
● Security feature for flash and RAM
● Always-on power-on reset (POR) circuitry
●### Development Support
● On-chip ICE
●### Multiple Serial Communication Options
● Serial communications interface module
● Option for 13-bit break capabilities
● Double-buffered transmit and receive
● Serial peripheral interface module
● I2C bus moduleComparison Table
●### Family Comparison
●##
●S08QG Family is pin and software compatible with RS08KA and S08QG 8-bit microcontrollers, offering greater design flexibility within Our Low-end Portfolio
●| S08QG| RS08KA| S08QD
●| |
●| |
●| |
●| |
●| |
●More information on Our Low-End portfolio.
●Quick guide for migration path between our Low-End Offerings
Part 3D Model
