MC9S08SH8CPJ Datasheet PDF - NXP

●The MC9S08SH8CPJ is a 8-bit General-purpose Microcontroller based on enhanced HCS08 CPU (20MHz bus) with CISC architecture operates at a maximum frequency of 40MHz. The device incorporates 8kB internal flash, 0.512kB internal RAM, an analog comparator, 12-channel 10-bit A/D converter and 17 general-purpose I/O pins. This device also features peripherals like one inter-integrated circuit (IIC) bus module to operate at up to 100kbps and one serial peripheral interface modules (SPI).

● HC08 Instruction set with added BGND instruction

● Support for up to 32 Interrupt/reset sources

● Two very low power stop modes

● Reduced power wait mode

● Very low power real time interrupt for use in run, wait and stop

● Loop-control Pierce oscillator (XOSC)

● Internal clock source (ICS)

● Watchdog computer operating properly (COP) reset

● Low-voltage detection with reset or interrupt - selectable trip points

● Illegal opcode detection with reset

● Illegal address detection with reset

● Flash block protect

● 8-bit Modulo counter with 8-bit prescaler and overflow interrupt

● Two 2-channel Timer PWM modules (TPM1, TPM2)

● 8 Interrupt pins with selectable polarity

● Hysteresis and configurable pull up device on all input pins

● Configurable slew rate and drive strength on all output pins

● Single-wire background debug interface

● Breakpoint capability to allow single breakpoint setting during in-circuit debugging

● In-circuit emulation (ICE) debug module