MCP2551-I/P Datasheet PDF - Microchip

●The MCP2551-I/P is a high speed CAN, fault tolerant device that serves as the interface between a CAN protocol controller and the physical bus. The MCP2551-I/P device provides differential transmit and receive capability for the CAN protocol controller, and is fully compatible with the ISO-11898 standard, including 24V requirements. It will operate at speeds of up to 1Mb/s. Typically, each node in a CAN system must have a device to convert the digital signals generated by a CAN controller to signals suitable for transmission over the bus cabling (differential output). It also provides a buffer between the CAN controller and the high voltage spikes that can be generated on the CAN bus by outside sources (EMI, ESD, electrical transients, etc.).

● Supports 1Mb/s operation

● Implements ISO-11898 standard physical layer requirements

● Suitable for 12V and 24V systems

● Externally controlled slope for reduced RFI emissions

● Detection of ground fault (permanent Dominant) on TXD input

● Power-on Reset and voltage brown-out protection

● An unpowered node or brown-out event will not disturb the CAN bus

● Low current standby operation

● Protection against damage due to short-circuit conditions (positive or negative battery voltage)

● Protection against high voltage transients

● Automatic thermal shutdown protection

● Up to 112 nodes can be connected

● High noise immunity due to differential bus implementation