●Overview
●The MPC8245 Integrated Host Processor supports applications where cost, space, power consumption and performance are critical requirements.
● Provides a high level of integration, significantly reducing system component cost
● Simplifies board design, reduces power consumption and accelerates faster-time-to-market
● Targets systems using PCI interfaces in networking infrastructure, telecommunications, and other embedded markets.
● Enables control processing for routers, switches, network storage applications and image display systems
●MoreLess
●## Features
●266-466 MHz MPC603e processor core
● 32-bit PCI interface operating at up to 66 MHz
● Memory controller offering SDRAM support up to 133 MHz operation, support up to 2 GB
● General Purpose I/O and ROM Interface Support
● Two-channel DMA controller that supports chaining
● Messaging unit with I2O messaging support capability
● Industry-standard I2C interface
● Programmable interrupt controller with multiple timers and counters
● 16550 compatible DUART
●Typical Applications
● Routers/Switches
● Multi-channel modems
● Network storage
● Image display systems
● Enterprise I/O processor
● Internet access device (IAD)
● Disk controller for RAID systems
● Copier/printer board control
●Processor Core and On-Chip Peripheral Logic Features
●MPC603e processor core
● High-performance, superscalar processor core
● Floating-point unit, integer, load/store, system register and branch processing unit
● 16K instruction cache, 16K data cache
● Lockable portion of L1 cache
● Dynamic power management
● Software-compatible with processors built on Power Architecture technology
●On-Chip Peripheral Logic
●Memory interface
● 133 MHz memory bus capability
● Programmable timing EDO DRAM or SDRAM
● High-bandwidth bus (32/64-bit data bus) to DRAM
● Supports one to eight banks of 16-, 64-, 128-, 256-, or 512 Mbit DRAM, and up to four banks of 256-Mbit SDRAM devices
● Supports 1 Mbyte to 2 Gbyte DRAM memory
● Contiguous memory mapping
● 256 Mbytes of ROM space
● 8-bit, 16-bit, 32-bit, or 64-bit ROM
● Supports bus-width writes to flash
● Read-modify-write parity support (selectable)
● ECC support (selectable)
● SDRAM, DRAM buffer data-path
● Error injection/capture on data path
● LVTTL compatible
● PortX: 8-, 32- or 64-bit general-purpose I/O port uses ROM controller interface with address strobe
●32-bit PCI interface operating up to 66 MHz
● PCI 2.2 compatible
● PCI 5.0 V tolerant
● Support for PCI locked accesses to memory
● Support for accesses to all PCI address spaces
● Selectable big- or little-endian operation
● Store gathering of processor-to-PCI writes and PCI-to-memory writes
● Memory prefetching of PCI read accesses
● Parity support (selectable)
● Selectable hardware-enforced coherency
● PCI bus arbitration unit (5 request/grant pairs
●PCI agent mode capability
● Address Translation Unit (ATU)
● Run time register access
● PCI configuration register access
●Two-channel integrated DMA controller
● Supports direct or chaining modes
● Scatter gather
● Interrupt on completed segment, chain, and error
● Local to local memory
● PCI to PCI memory
● PCI to local memory
● Local to PCI memory
●Message Unit
● (I2O) Intelligent Input/Output Message Controller
● Two door-bell registers
● Inbound and outbound messaging registers
●(I2C) Inter-Integrated Circuit Controller
● Full master/slave support
●Embedded programmable interrupt controller (EPIC)
● Five hardware interrupts (IRQs) or 16 serial interupts
● Four programmable timers
●Integrated PCI bus and SDRAM clock generation
●Programmable memory and PCI bus drivers
●Debug Features
● Watchpoint monitor
● Memory attribute and PCI attribute signals
● JTAG/COP—Common On-board Processor for in-circuit hardware debugging
●Dual UART
● 16550 Compatible
●## Features
