MSP430F2410TPM Datasheet PDF - TI

●The MSP430F2410TPM is a 16-bit ultra-low-power Mixed-signal Microcontroller features a powerful 16-bit RISC MSP430 CPU, 16-bit registers and constant generators that contribute to maximum code efficiency. The architecture combined with five low-power modes, is optimized to achieve extended battery life. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1µs. The device configurations with two 16-bit timers, 12-bit A/D converter, a comparator, a hardware multiplier, four universal serial communication interface (USCI) modules and 48 general-purpose I/O pins. This device operates at a maximum frequency of 16MHz.

● 16-bit RISC architecture, 62.5ns instruction cycle time

● Internal frequencies up to 16MHz with four calibrated frequencies to ±1%

● Internal very-low-power low-frequency oscillator

● 32kHz Crystal

● Resonator clock

● External digital clock source

● External resistor

● 12-bit ADC with internal reference, sample-and-hold and autoscan feature

● 16-bit Timer_A with 3 Capture/Compare registers

● 16-bit Timer_B with 7 Capture/Compare registers

● Enhanced UART supporting auto-baudrate detection

● IrDA Encoder and decoder

● Synchronous SPI

● On-chip comparator

● Supply voltage supervisor/monitor with programmable level detection

● Brownout detector

● Bootstrap loader

● Serial on-board programming

● No external programming voltage needed

● Programmable code protection by security fuse