MSP430G2533IN20 Datasheet PDF - TI

●The MSP430G2533IN20 is a 16-bit ultra-low-power Mixed-signal Microcontroller features a powerful 16-bit RISC MSP430 CPU, 16-bit registers and constant generators that contribute to maximum code efficiency. The architecture combined with five low-power modes, is optimized to achieve extended battery life. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1µs. The device configurations with two 16-bit timers, 10-bit A/D converter, built-in communication capability using the USCI and 24 general-purpose I/O pins. This device operates at a maximum frequency of 16MHz.

● 16-bit RISC architecture, 62.5ns instruction cycle time

● Internal frequencies up to 16MHz with four calibrated frequencies

● Internal very-low-power low-frequency oscillator

● 32kHz Crystal

● External digital clock source

● Two 16-bit Timer_A with 3 Capture/Compare registers

● Up to 24 Capacitive-touch enabled I/O pins

● Enhanced UART supports automatic baud-rate detection (LIN)

● IrDA Encoder and decoder

● Synchronous SPI

● 10-bit 200ksps ADC with internal reference, sample-and-hold and autoscan

● Brownout detector

● Serial on-board programming

● No external programming voltage needed

● Programmable code protection by security fuse

● On-chip emulation logic with spy-bi-wire interface

● 230µA at 1MHz, 2.2V Active mode (AM) power consumption