MSP430I2041TRHBT Datasheet PDF - TI

●The MSP430I2041TRHBT is a 16-bit Mixed-signal Microcontroller features a powerful 16-bit RISC MSP430 CPU, 16-bit registers and constant generators that contribute to maximum code efficiency. The architecture combined with five low-power modes, is optimized to achieve extended battery life. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1µs. The device configurations with a power management module (PMM) with built-in voltage reference and voltage monitor, two 16-bit timers, four 24-bit sigma-delta A/D converter, a hardware multiplier, a temperature sensor, one eUSCI-A module, one eUSCI-B module, a watchdog timer (WDT) and 16 general-purpose I/O pins. This device operates at a maximum frequency of 16MHz.

● Integrated LDO with 1.8V regulated core supply voltage

● Supply voltage monitor with programmable level detection

● Brownout detector

● Built-in voltage reference

● Temperature sensor

● 16.384MHz Internal DCO

● DCO operation with internal or external resistor

● External digital clock source

● Up to four 24-bit sigma-delta ADC with differential PGA inputs

● Two 16-bit Timers with 3 Capture/Compare registers each

● Enhanced UART with automatic baud-rate detection

● IrDA Encoder and decoder

● Synchronous SPI

● 16-bit Hardware multiplier

● Serial on-board programming

● No external programming voltage needed

● Programmable code protection

● On-chip emulation module