●Overview
●The SC16IS752/SC16IS762 is an I²C-bus/SPI bus interface to a dual-channel high performance UART offering data rates up to 5 Mbit/s, low operating and sleeping current; it also provides the application with 8 additional programmable I/O pins. The device comes in very small HVQFN32 and TSSOP28 packages, which makes it ideally suitable for hand-held, battery-operated applications. This chip enables seamless protocol conversion from I²C-bus/SPI to RS-232/RS-485 and is fully bidirectional.
●The SC16IS762 differs from the SC16IS752 in that it supports SPI clock speeds up to 15 Mbit/s instead of the 4 Mbit/s supported by the SC16IS752, and in that it supports IrDA SIR up to 1.152 Mbit/s. In all other aspects, the SC16IS762 is functionally and electrically the same as the SC16IS752.
●The SC16IS752/SC16IS762’s internal register set is backward compatible with the widely used and widely popular 16C450. This allows the software to be easily written or ported from another platform.
●The SC16IS752/SC16IS762 also provides additional advanced features such as auto hardware and software flow control, automatic RS-485 support and software reset. This allows the software to reset the UART at any moment, independent of the hardware reset signal.
●MoreLess
●## Features
●### General features
● Dual full-duplex UART
● I²C-bus or SPI interface selectable
● 3.3 V or 2.5 V operation
● Industrial temperature range: -40 °C to +95 °C
● 64 bytes FIFO (transmitter and receiver)
● Fully compatible with industrial standard 16C450 and equivalent
● Baud rates up to 5 Mbit/s in 16× clock mode
● Auto hardware flow control using RTS/CTS
● Auto software flow control with programmable Xon/Xoff characters
● Single or double Xon/Xoff characters
● Automatic RS-485 support (automatic slave address detection)
● Up to eight programmable I/O pins
● RS-485 driver direction control via RTS signal
● RS-485 driver direction control inversion
● Built-in IrDA encoder and decoder supporting IrDA SIR with speeds up to 115.2 kbit/s
● SC16IS762 supports IrDA SIR with speeds up to 1.152 Mbit/s
● Software reset
● Transmitter and receiver can be enabled/disabled independent of each other
● Receive and Transmit FIFO levels
● Programmable special character detection
● Fully programmable character formatting
● 5-bit, 6-bit, 7-bit or 8-bit character
● Even, odd, or no parity
● 1, 1½, or 2 stop bits
● Line break generation and detection
● Internal Loopback mode
● Sleep current less than 30 μA at 3.3 V
● Industrial and commercial temperature ranges
● 5 V tolerant inputs
● Available in HVQFN32 and TSSOP28 packages
●### I²C-bus features
● Noise filter on SCL/SDA inputs
● 400 kbit/s (maximum)
● Compliant with I²C-bus Fast mode
● Slave mode only
●### SPI features
● SC16IS752 supports 4 Mbit/s maximum SPI clock speed
● SC16IS762 supports 15 Mbit/s maximum SPI clock speed
● SPI Mode 0
●## Features
Part 3D Model
