●This 8-bit noninverting bus transceiver uses two separate configurable power-supply rails. The SN74AVC8T245 is optimized to operate with VCCA/VCCB set at 1.4 V to 3.6 V. The device is operational with VCCA/VCCB as low as 1.2 V. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.2 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.2 V to 3.6 V. This allows for universal low-voltage bidirectional translation between any of the 1.2-V, 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes.
●The SN74AVC8T245 is designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE) input can be used to disable the outputs so the buses are effectively isolated.
●The SN74AVC8T245 is designed so the control pins (DIR and OE) are supplied by VCCA.
●The SN74AVC8T245 solution is compatible with a single-supply system and can be replaced later with a 245 function, with minimal printed circuit board redesign.
●This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, thus preventing damaging current backflow through the device when it is powered down.
●The VCC isolation feature ensures that if either VCC input is at GND, both ports are in the high-impedance state.
●To ensure the high-impedance state during power up or power down, OE shall be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the
● Control Inputs VIH/VIL Levels Are Referenced to VCCA Voltage
● VCC Isolation Feature If Either VCC Input Is at GND, All I/O
●Ports Are in the High-Impedance State
● Ioff Supports Partial Power-Down Mode Operation
● Fully Configurable Dual-Rail Design Allows Each Port to Operate
●Over the Full 1.4-V to 3.6-V Power-Supply Range
● I/Os Are 4.6-V Tolerant
● Maximum Data Rates
● 170 Mbps (VCCA < 1.8 V or VCCB < 1.8 V)
● 320 Mbps (VCCA ≥ 1.8 V and VCCB ≥ 1.8 V)
● Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
● ESD Protection Exceeds JESD 22
● 8000-V Human-Body Model (A114-A)
● 200-V Machine Model (A115-A)
● 1000-V Charged-Device Model (C101)
