●These 8-bit flip-flops feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. They are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
●The eight flip-flops of the \x92HC374 devices are edge-triggered D-type flip-flops. On the positive transition of the clock (CLK) input, the Q outputs are set to the logic levels that were set up at the data (D) inputs.
●An output-enable (OE) input places the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without interface or pullup components.
●OE does not affect the internal operations of the flip-flops. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
●To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
● Wide Operating Voltage Range of 2 V to 6 V
● High-Current 3-State True Outputs Can
●Drive Up To 15 LSTTL Loads
● Eight D-Type Flip-Flops in a Single Package
● Full Parallel Access for Loading
● Low Power Consumption, 80-µA Max ICC
● Typical tpd = 14 ns
● ±6-mA Output Drive at 5 V
● Low Input Current of 1 µA Max
