●The TMS320C32 is the newest member of the TMS320C3x generation of digital signal processors (DSPs) from Texas Instruments. The TMS320C32 is an enhanced 32-bit floating-point processor manufactured in 0.7-um triple-level-metal CMOS technology. The enhancements to the TMS320C3x architecture include a variable-width external-memory interface, faster instruction cycle time, power-down modes, two-channel DMA coprocessor with configurable priorities, flexible boot loader, relocatable interrupt-vector table, and edge- or level-triggered interrupts.
● High-Performance Floating-Point DSP
● TMS320C32-60 (5 V)
●33-ns Instruction Cycle Time
●330 Million Operations Per Second (MOPS), 60 Million Floating-Point Operations Per Second (MFLOPS), 30 Million Instructions Per Second (MIPS)
● TMS320C32-50 (5 V)
●40-ns Instruction Cycle Time
●275 MOPS, 50 MFLOPS, 25 MIPS
● TMS320C32-40 (5 V)
●50-ns Instruction Cycle Time
●220 MOPS, 40 MFLOPS, 20 MIPS
● 32-Bit High-Performance CPU
● 16-/32-Bit Integer and 32-/40-Bit Floating-Point Operations
● 32-Bit Instruction Word, 24-Bit Addresses
● Two 256 × 32-Bit Single-Cycle, Dual-Access On-Chip RAM Blocks
● Flexible Boot-Program Loader
● On-Chip Memory-Mapped Peripherals:
● One Serial Port
● Two 32-Bit Timers
● Two-Channel Direct Memory Access (DMA) Coprocessor With Configurable Priorities
● Enhanced External Memory Interface That Supports 8-/16-/32-Bit-Wide External RAM for Data Access and Program Execution From 16-/32-Bit-Wide External RAM
● TMS320C30 and TMS320C31 Object Code Compatible
● Fabricated using 0.7 um Enhanced Performance Implanted CMOS (EPICTM) Technology by Texas Instruments (TITM)
● 144-Pin Plastic Quad Flat Package
●(PCM Suffix) 5 V
● Eight Extended-Precision Registers
● Two Address Generators With Eight Auxiliary Registers and Two Auxiliary Register Arithmetic Units (ARAUs)
● Two Low-Power Modes
● Two- and Three-Operand Instructions
● Parallel Arithmetic Logic Unit (ALU) and Multiplier Execution in a Single Cycle
● Block-Repeat Capability
● Zero-Overhead Loops With Single-Cycle Branches
● Conditional Calls and Returns
● Interlocked Instructions for Multiprocessing Support
● One External Pin, PRGW, That Configures the External-Program-Memory Width to
●16 or 32 Bits
● Two Sets of Memory Strobes (STRB0\ and STRB1\\) and One I/O Strobe (IOSTRB\\) Allow Zero-Glue Logic Interface to Two Banks of Memory and One Bank of External Peripherals
● Separate Bus-Control Registers for Each Strobe-Control Wait-State Generation, External Memory Width, and Data Type Size
● STRB0\ and STRB1\ Memory Strobes Handle 8-, 16-, or 32-Bit External Data Accesses (Reads and Writes)
● Multiprocessor Support Through the HOLD\ and HOLDA\ Signals Is Valid for All Strobes
●EPIC and TI are trademarks of Texas Instruments Incorporated.
