TPS63030DSKT Datasheet PDF - TI

●The TPS63030DSKT is a High Efficient Single Inductor Buck-boost Converter with 1A switches that provide a power supply solution for products powered by either a two-cell or three-cell alkaline, NiCd or NiMH battery or a one-cell Li-ion or Li-polymer battery. The buck-boost converter is based on a fixed frequency, pulse width modulation (PWM) controller using synchronous rectification to obtain maximum efficiency. At low load currents, the converter enters power-save mode to maintain high efficiency over a wide load current range. The power-save mode can be disabled, forcing the converter to operate at a fixed switching frequency. The maximum average current in the switches is limited to a typical value of 1000mA. The output voltage is programmable using an external resistor divider or is fixed internally on the chip. The converter can be disabled to minimize battery drain. During shutdown, the load is disconnected from the battery.

● Up to 96% efficiency

● 800mA Output current at 3.3V in step down mode (VIN = 3.6 to 5.5V)

● Up to 500mA output current at 3.3V in boost mode (VIN >2.4V)

● Automatic transition between step down and boost mode

● Less than 50µA device quiescent current

● Power save mode for improved efficiency at low output power

● Forced fixed frequency operation and synchronization possible

● Load disconnect during shutdown

● Over-temperature protection

● Green product and no Sb/Br

●This device has limited built-in ESD protection, leads should be shorted together or the device placed in conductive foam during storage or handling to prevent electrostatic damage to the MOS gates.