●The TPS63060DSCR is a high input voltage Buck-boost Converter with 2A switch current, provides a power supply solution for products powered by either three-cell up to six-cell alkaline, NiCd or NiMH battery or a one-cell or dual-cell Li-ion or Li-polymer battery. Output currents can go as high as 2A while using a dual-cell Li-Ion or Li-polymer battery and discharge it down to 5V or lower. The buck-boost converter is based on a fixed frequency, pulse-width-modulation (PWM) controller using synchronous rectification to obtain maximum efficiency. At low load currents, the converter enters power-save mode to maintain high efficiency over a wide load current range. The power-save mode can be disabled, forcing the converter to operate at a fixed switching frequency. The maximum average current in the switches is limited to a typical value of 2.25A. The output voltage is programmable using an external resistor divider or is fixed internally on the chip.
● Up to 93% efficiency
● 2A at 5V (buck mode, VIN<10V), 1.3A at 5V (boost mode, VIN>4V) Output current
● Automatic transition between step down and boost mode
● <30µA Typical device quiescent current
● Fixed and adjustable output voltage options from 2.5 to 8V
● Power-save mode for improved efficiency at low output power
● Forced fixed-frequency operation at 2.4MHz and synchronization possible
● Power good output
● Buck-boost overlap control
● Load disconnect during shutdown
● Over-temperature protection
● Overvoltage protection
● Green product and no Sb/Br
●Device has limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam during storage or handling to prevent electrostatic damage to the MOS gates.
