●The TPS65217CRSLT is a single-chip Power Management IC specifically designed to support applications in portable and 5V non-portable applications. It provides a linear battery charger for single-cell Li-ion and Li-Polymer batteries, dual-input power path, three step-down converters, four LDOs and a high-efficiency boost converter to power two strings of up to 10 LEDs each. The system can be supplied by any combination of USB port, 5VAC adaptor or Li-Ion battery. The device is characterized across a -40 to +105°C temperature range. Three high-efficiency 2.25MHz step-down converters can provide the core voltage, memory and I/O voltage for a system. This step-down converter enters a low power mode at light load for maximum efficiency across the widest possible range of load currents. For low-noise applications the devices can be forced into fixed frequency PWM using the I2C interface.
● Charger/power path - 2A output current on power path
● Charger/power path - 20V tolerant USB and AC inputs
● Charger/power path - thermal regulation, safety timers
● Charger/power path - temperature sense input
● Step-down converter (DCDC1, 2, 3) - Three step-down converters with integrated switching FETs
● Step-down converter (DCDC1, 2, 3) - Power save mode at light load current
● Step-down converter (DCDC1, 2, 3) - 100% duty cycle for lowest dropout
● Step-down converter (DCDC1, 2, 3) - Passive discharge to ground when disabled
● LDOs (LDO1, 2) - two adjustable LDOs
● LDOs (LDO1, 2) - LD02 can be configured to track DCDC3
● LDOs (LDO1, 2) - typical 15pA quiescent current
● Load switches (LDO3, 4) - two independent load switches that can be configured as LDOs
● WLED driver - Internally generated PWM for dimming control
● WLED driver - supports two strings of up to 10 LEDs at 25mA each
● WLED driver - Internal low-side current sinks
● Protection - Undervoltage lockout and battery fault comparator
● Protection - Always-on push-button monitor
● Protection - Hardware reset pin
● Interface - password protected I2C registers