TXS0104E Datasheet PDF - TI

●This 4-bit non-inverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.65 V to 3.6 V. VCCA must be less than or equal to VCCB. The B port is designed to track VCCB. VCCB accepts any supply voltage from 2.3 V to 5.5 V. This allows for low-voltage bidirectional translation between any of the 1.8-V, 2.5-V, 3.3-V, and 5-V voltage nodes.

●When the output-enable (OE) input is low, all outputs are placed in the high-impedance state.

●The TXS0104E is designed so that the OE input circuit is supplied by VCCA.

●To ensure the high-impedance state during power up or power down, OE should be tied to GND through a pulldown resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver.

● No Direction-Control Signal Needed

● Max Data Rates

● 24 Mbps (Push Pull)

● 2 Mbps (Open Drain)

● Available in the Texas Instruments NanoFree™

●Package

● 1.65 V to 3.6 V on A port and 2.3 V to 5.5 V on B

●port (VCCA – VCCB)

● No Power-Supply Sequencing Required – VCCA or

●VCCB Can Be Ramped First

● Latch-Up Performance Exceeds 100 mA Per

●JESD 78, Class II

● ESD Protection Exceeds JESD 22

● A Port

● 2000-V Human-Body Model (A114-B)

● 200-V Machine Model (A115-A)

● 1000-V Charged-Device Model (C101)

● B Port

● 15-kV Human-Body Model (A114-B)

● 200-V Machine Model (A115-A)

● 1000-V Charged-Device Model (C101)

● IEC 61000-4-2 ESD (B Port)

● ±8-kV Contact Discharge

● ±10-kV Air-Gap Discharge