UCD9090RGZT Datasheet PDF - TI

●The UCD9090RGZT is a 10-channel Sequencer and System Health Monitor with ACPI support. The device integrates a 12-bit ADC for monitoring up to 10 power-supply voltage inputs. Twenty-three GPIO pins can be used for power supply enables, power-on reset signals, external interrupts, cascading or other system functions. Ten of these pins offer PWM functionality. Using these pins, the UCD9090 offers support for margining and general-purpose PWM functions. Specific power states can be achieved using the pin-selected rail states feature. This feature allows with the use of up to 3 GPIs to enable and disable any rail. This is useful for implementing system low-power modes and the advanced configuration and power interface (ACPI) specification that is used for hardware devices. The TI fusion Digital Power™ designer software is provided for device configuration.

● All rails sampled every 400µs

● 12-bit ADC with 2.5V, 0.5% internal VREF

● Sequence based on time, rail and pin dependencies

● Four programmable under-voltage and over-voltage thresholds per monitor

● Non-volatile error and peak-value logging per monitor (up to 30 fault detail entries)

● Closed-loop margining for 10 rails

● Programmable watchdog timer and system reset

● Flexible digital I/O configuration

● Clock frequencies from 15.259kHz to 125MHz

● Capability to configure independent clock outputs for synchronizing switch-mode power supplies

● JTAG and I²C/SMBus/PMBus™ interfaces

● Green product and no Sb/Br