X9C103SZ Datasheet PDF - Intersil

●The X9C103SZ is a Digitally Controlled (XDCP) Potentiometer consists of a resistor array, wiper switches, a control section and non-volatile memory. The wiper position is controlled by a three-wire interface. The potentiometer is implemented by a resistor array composed of 99 resistive elements and a wiper switching network. Between each element and at either end are tap points accessible to the wiper terminal. The position of the wiper element is controlled by the CS, U/D and INC inputs. The position of the wiper can be stored in non-volatile memory and then be recalled upon a subsequent power-up operation. The device can be used as a three-terminal potentiometer or as a two-terminal variable resistor in a wide variety of applications ranging from control to signal processing to parameter adjustment.

● Solid-state potentiometer

● Three-wire serial interface

● 100 Wiper tap points

● Wiper position stored in non-volatile memory and recalled on power-up

● 99 Resistive elements - Temperature compensated, ±5V terminal voltages

● Low power CMOS - VCC = 5V, 3mA maximum active current, 750µA maximum standby current

● High reliability - 100,000 endurance data changes per bit

● 100 years Register data retention

●ESD sensitive device, take proper precaution while handling the device.