MAX213 Datasheet PDF

● ESD Protection for RS-232 Bus Pins

● ±15-kV Human-Body Model (HBM)

● Meets or Exceeds the Requirements of TIA/EIA-232-F and ITU v.28 Standards

● Operates at 5-V VCC Supply

● Four Drivers and Five Receivers

● Operates up to 120 kbit/s

● Low Supply Current in Shutdown Mode . . . 15 µA Typ

● External Capacitors . . . 4 × 0.1 F

● Designed to Be Interchangeable With Maxim MAX213

● Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II

● APPLICATIONS

● Battery-Powered Systems

● PDAs

● Notebooks

● Laptops

● Palmtop PCs

● Hand-Held Equipment

●## DESCRIPTION/ ORDER INFORMATION

●The MAX213 device consists of four line drivers, five line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 5-V supply. The devices operate at data signaling rates up to 120 kbit/s and a maximum of 30-V/µs driver output slew rate.

●The MAX213 has an active-low shutdown (SHDN) and an active-high enable control (EN). In shutdown mode, the charge pumps are turned off, V+ is pulled down to VCC, V– is pulled to GND, and the transmitter outputs are disabled. This reduces supply current typically to 1 µA. Two receivers of the MAX213 are active during shutdown.