NCP1014 Datasheet PDF

●The NCP101X series integrates a fixed−frequency current−mode controller and a 700 V MOSFET. Housed in a PDIP−7 or SOT−223 package, the NCP101X offers everything needed to build a rugged and low−cost power supply, including soft−start, frequency jittering, short−circuit protection, skip−cycle, a maximum peak current setpoint and a Dynamic Self−Supply (no need for an auxiliary winding).

●Unlike other monolithic solutions, the NCP101X is quiet by nature: during nominal load operation, the part switches at one of the available frequencies (65 − 100 − 130 kHz). When the current setpoint falls below a given value, e.g. the output power demand diminishes, the IC automatically enters the so−called skip−cycle mode and provides excellent efficiency at light loads. Because this occurs at typically 1/4 of the maximum peak value, no acoustic noise takes place. As a result, standby power is reduced to the minimum without acoustic noise generation.

●Features

●• Built−in 700 V MOSFET with Typical RDSon of 11 Ω and 22 Ω

●• Large Creepage Distance Between High−Voltage Pins

●• Current−Mode Fixed Frequency Operation: 65 kHz – 100 kHz − 130 kHz

●• Skip−Cycle Operation at Low Peak Currents Only: No Acoustic Noise!

●• Dynamic Self−Supply, No Need for an Auxiliary Winding

●• Internal 1.0 ms Soft−Start

●• Latched Overvoltage Protection with Auxiliary Winding Operation

●• Frequency Jittering for Better EMI Signature

●• Auto−Recovery Internal Output Short−Circuit Protection

●• Below 100 mW Standby Power if Auxiliary Winding is Used

●• Internal Temperature Shutdown

●• Direct Optocoupler Connection

●• SPICE Models Available for TRANsient Analysis

●• These are Pb−Free and Halide−Free Devices

●Typical Applications

●• Low Power AC/DC Adapters for Chargers

●• Auxiliary Power Supplies (USB, Appliances,TVs, etc.)