SN65LVDS9638DGKR Datasheet PDF - TI

●The SN65LVDS9638DGKR is a differential Line Driver implements the electrical characteristics of low-voltage differential signaling (LVDS). This signaling technique lowers the output voltage levels of 5V differential standard levels (such as TIA/EIA-422B) to reduce the power, increase the switching speeds and allow operation with a 3.3V supply rail. Any of the four current-mode drivers will deliver a minimum differential output voltage magnitude of 247mV into a 100R load when enabled. The intended application of this device and signaling technique is both point-to-point and multidrop (one driver and multiple receivers) data transmission over controlled impedance media of approximately 100R. The transmission media may be printed-circuit board traces, backplanes or cables. The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media and the noise coupling to the environment.

● Low-voltage TTL (LVTTL) logic input levels

● Driver at high-impedance when disabled or with VCC=0

● Pin-compatible with AM26LS31, MC3487 and µA9638

● Cold sparing for space and high-reliability applications requiring redundancy

● Low-voltage differential signaling with typical output voltage of 350mV and a 100R load

● Typical output voltage rise and fall time of 500ps (400Mbps)

● Typical propagation delay time of 1.7ns

● Operate from a single 3.3V supply

● Bus-terminal ESD protection exceeds 8kV

● Power dissipation 25mW at 200MHz/driver (typical)

● Green product and no Sb/Br