SN74LVC1T45DBVR Datasheet PDF - TI

●The SN74LVC1T45DBVR is a Single-bit Dual-supply Bus Transceiver with configurable voltage translation and 3-state outputs. This single-bit non-inverting bus transceiver uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.65 to 5.5V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.65 to 5.5V. This allows for universal low-voltage bidirectional translation between any of the 1.8, 2.5, 3.3 and 5V voltage nodes. Designed for asynchronous communication between two data buses. The logic levels of the direction-control (DIR) input activate either the B-port outputs or the A-port outputs. The device transmits data from the A bus to the B bus when the B-port outputs are activated and from the B bus to the A bus when the A-port outputs are activated. The input circuitry on both A and B ports always is active and must have a logic HIGH or LOW level applied to prevent excess ICC and ICCZ.

● Port to operate over full 1.65 to 5.5V power supply range

● VCC isolation feature

● DIR input circuit referenced to VCCA

● Low power consumption, 4µA maximum ICC

● ±24mA Output drive at 3.3V

● Ioff supports partial power-down mode operation

● 420, 210, 140 and 75Mbps Maximum data rates

● Latch-up performance exceeds 100mA per JESD 78, class II

● Green product and no Sb/Br

●Device has limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam during storage or handling to prevent electrostatic damage to the MOS gates.