STM32F401VCT6 Datasheet PDF - ST Microelectronics

●The STM32F401VCT6 is a STM32 F4 series 32-bit Microcontroller based on the high-performance ARM Cortex-M4 RISC core operating at a frequency of up to 84MHz. Its Cortex-M4 core features a floating point unit (FPU) single precision which supports all ARM single precision data-processing instructions and data types. It also implements a full set of DSP instructions and a memory protection unit (MPU) which enhances application security. The device incorporate high-speed embedded memories (up to 256kB of Flash memory, up to 64kB of SRAM) and an extensive range of enhanced I/Os and peripherals connected to two APB buses, two AHB buses and a 32-bit multi-AHB bus matrix. This device offer one 12-bit ADC, a low-power RTC, six general-purpose 16-bit timers including one PWM timer for motor control, two general-purpose 32-bit timers, as well as standard communication interfaces - up to three I²Cs, four SPIs, two I²Ss and three USARTs.

● 105 DMIPS/1.25 DMIPS/MHz (Dhrystone 2.1)

● 4 to 26MHz Crystal oscillator

● Internal 16MHz factory-trimmed RC

● 32kHz Oscillator for RTC with calibration

● Internal 32kHz RC with calibration

● 16-stream DMA Controller with FIFOs and burst support

● Serial wire debug (SWD) and JTAG interfaces

● Cortex-M4 Embedded Trace Macrocell™

● SDIO interface

● USB 2.0 full speed device/host/OTG controller with on-chip PHY

● CRC calculation unit

● 96-bit Unique ID

● RTC - subsecond accuracy, hardware calendar